Fujitsu D2156 Kurzanleitung Seite 17

Procedure
The processor slot is covered with a protective cap to protect the spring
contacts In a warranty case the mainboard can only be taken back by Fujitsu
Technology Solutions with the protective cap secured!
b
Please note that, depending on the heat sink used, different heat sink
mounts are required on the mainboard.
► Depending on the configuration variant, you must pull a protective foil off the heat sink
or coat the heat sink with heat conducting paste before fitting it.
► Secure the heat sink - depending on the model - with four screws or push it into the mounts.
A26361-D2156-Z212-1-8N19, edition 1
b
a
Brief description of the mainboard
► Remove the heat sink.
► Press down the lever and unhook it.
► Fold up the bracket.
► Hold the processor between your thumb
and index finger and insert it into the slot
(b) so that the marking of the processor is
aligned with the marking on the slot (a).
► Press the lever downward until it is
hooked in again.
► Remove the protective cap and keep it.
English - 3