Downloading Further Instructions - Balluff BTL6-A/C/E/G500-M_ _ _ _-PF-S115 Serie Kurzanleitung

BTL6-A/C/E/G500-M_ _ _ _-PF-S115
Micropulse Transducer in a Flat Profile Housing
The CE Mark verifies that our products
meet the requirements of the current
EMC Directive.
Intended use
The BTL6 Micropulse Transducer, together with a machine
controller (e.g. PLC), comprises a position measuring
system. It is intended to be installed into a machine or
system. Flawless function in accordance with the
specifications in the technical data is ensured only when
using original BALLUFF accessories. Use of any other
components will void the warranty.
Opening the transducer or non-approved use are not
permitted and will result in the loss of warranty and liability
claims against the manufacturer.
General safety notes
Installation and startup may only be performed by
trained specialists.
The operator is responsible for ensuring that local safety
regulations are observed. In particular, the operator must
take steps to ensure that a defect in the position
measuring system will not result in hazards to persons or
equipment.
If defects and unresolvable faults occur in the transducer, it
should be taken out of service and secured against
unauthorized use.

Downloading further instructions

A complete user's guide can be downloaded from the
Internet at www.balluff.com or requested via e-mail from
service@balluff.de.
Output signal rising:
Error signal
100 %
0 %
Null point
1)
13 73
~80
1 english english
End point
Nominal length =
Measuring range
2)
~250 ~250
Mounting clamps with insulating bushes
and ISO 4762 M5x25 cylinder-head screws,
max. tightening torque 2 Nm
Dimensions and function
The transducer contains the waveguide. A magnet is
moved along the waveguide. This magnet defines the
position to be measured on the waveguide.
In normal operation the LED indicates the operating states
of the transducer.
LED Operating state
Green Normal function
Magnet is within the limits.
Red Error
No magnet or magnet outside the limits.
Installation
NOTICE!
Improper installation
Improper installation can compromise the function of the
transducer and result in damage.
► For this reason, ensure that no strong electrical or
magnetic fields are present in the immediate vicinity
of the transducer.
► The recommended spacing for the installation must
be strictly observed.
Any orientation is permitted. Mount the transducer on a
level surface of the machine using the provided mounting
clamps and cylinder-head screws. A sufficient number of
mounting clamps is supplied.
1) Unusable area
2) Not included in scope of
1)
73
~80
15
File no.
E227256
delivery
2)
BTL5-P-3800-2 magnet
34.8
50
LED
68