Downloading Further Instructions - Balluff BTL7-A5 Serie Kurzanleitung

BTL7-A5 _ _ -M _ _ _ _ -K(8)-SA264-SR32/K _ _(-ZA0W)
Micropulse Transducer - Rod Style
EU Directive 2004/108/EG (EMC Directive) and EMC law
Noise immunity: EN 61000-6-1/EN 61000-6-2
Emission: EN 61000-6-3/EN 61000-6-4
Intended use
The BTL7 Micropulse Transducer, together with a machine
controller (e.g. PLC), comprises a position measuring
system. It is intended to be installed into a machine or
system. Flawless function in accordance with the
specifications in the technical data is ensured only when
using original BALLUFF accessories. Use of any other
components will void the warranty.
Opening the transducer or non-approved use are not
permitted and will result in the loss of warranty and liability
claims against the manufacturer.
General safety notes
Installation and startup may only be performed by
trained specialists.
The operator is responsible for ensuring that local safety
regulations are observed. In particular, the operator must
take steps to ensure that a defect in the position
measuring system will not result in hazards to persons or
equipment.
If defects and unresolvable faults occur in the transducer, it
should be taken out of service and secured against
unauthorized use.
BTL7...-SR32
34 40-1
6
1)
Magnet
Mounting
25
surface
M16
20.5
1 english
Damping zone
Nominal length =
Measuring range
2)
D1
Version
...-K-... 10.2 mm
...-K8-...
BTL7...-K_ _-ZA0W

Downloading further instructions

A complete standard user's guide can be downloaded
from the Internet at www.balluff.com/downloads-btl7
or requested via e-mail from service@balluff.de.
Dimensions and function
The BTL7 transducer contains the waveguide which is
protected by an outer stainless steel tube (rod). A magnet
is moved along the waveguide. This magnet is connected
to the system part whose position is to be determined.
SA264:
Deviation from standard
– Output voltage: 0...5 V or 5...0 V
1)
60
G
G
Thread
M4x4/6 deep
8 mm No thread
BTL7...-K_ _
3)
r
20.5
1) Unusable area
2) Not included in scope of delivery
3) The bending radius for a fixed cable must be at
least five times the cable diameter.
M16
File no.
E227256
Ø 79
Ø 64
6 holes for
mounting the
transducer