Declaration Of Conformity - Bosch GBS 100 A Bedienungsanleitung

2 610 936 860.book Seite 4 Mittwoch, 26. Oktober 2005 3:27 15
Replacing the Graphite Plate
(see figure )
D
The graphite plate 12 (accessory) is screwed
onto the guide plate 11. It enables an optimum
sanding pattern.
The graphite plate 12 is subject to wear, depend-
ing on the intensity of usage. To maintain opti-
mum sanding capacity, the graphite plate must
be replaced in good time when it is worn.
Remove the sanding belt for this. Unscrew and
remove the worn graphite plate. Then adjust the
belt run as described in the section "Changing the
Sanding Belt".
If the machine should fail despite the care taken
in manufacturing and testing procedures, repair
should be carried out by an authorized after-sales
service agent for Bosch power tools.
In all correspondence and spare parts orders,
please always include the 10-digit article number
given on the nameplate of the machine.
WARNING! Important instructions for con-
necting a new 3-pin plug to the 2-wire cable.
The wires in the cable are coloured according to
the following code:
strain relief
live = brown
neutral = blue
Do not connect the blue or brown wire to the
earth terminal of the plug.
Important: If for any reason the moulded plug is
removed from the cable of this machine, it must
be disposed of safely.
Disposal
Power tools, accessories and packaging should
be sorted for environmental-friendly recycling.
Only for EC countries:
Do not dispose of power tools into
household waste!
According to the European Direc-
tive 2002/96/EC on waste electrical
and electronic equipment and its in-
corporation into national law, power
tools that are no longer suitable for use must be
separately collected and sent for recovery in an
environmental-friendly manner.
14 • 2 610 936 860 • TMS • 17.10.05
Service and
Customer Assistance
Exploded views and information on spare
parts can be found under:
www.bosch-pt.com
Great Britain
Robert Bosch Ltd. (B.S.C.)
P.O. Box 98
Broadwater Park
North Orbital Road
Denham-Uxbridge
Middlesex UB 9 5HJ
Fax
Ireland
Beaver Distribution Ltd.
Greenhills Road
Tallaght-Dublin 24
Fax
Australia and New Zealand
Robert Bosch Australia Pty. Ltd.
RBAU/SPT
1555 Centre Road
To be fitted
P.O. Box 66
by qualified
3168 Clayton/Victoria
professional only
Fax
www.bosch.com.au
We declare under our sole responsibility that this
product is in conformity with the following stand-
ards or standardization documents: EN 60 745
according to the provisions of the directives
89/336/EEC, 98/37/EC.
Dr. Egbert Schneider
Senior Vice President
Engineering
Robert Bosch GmbH, Power Tools Division
Subject to change without notice
English - 4
Service +44 (0) 18 95 / 83 87 82
............................
Advice line +44 (0) 18 95 / 83 87 91
....................
+44 (0) 18 95 / 83 87 89
.............................................
Service +353 (0)1 / 414 9400
...................................
+353 (0)1 / 459 8030
....................................................
+61 (0)1 / 3 00 30 70 44
.............................................
+61 (0)1 / 3 00 30 70 45
.............................................

Declaration of Conformity

Dr. Eckerhard Strötgen
Head of Product
Certification