Makita LCT303X Bedienungsanleitung Seite 51

ENGLISH
1-1. Button
1-2. Battery cartridge
2-1. Switch trigger
3-1. Lamp
SPECIFICATIONS
Capacities
No load speed (min
Impacts per minute
• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
• Note: Specifications may differ from country to country.
Intended use
The tool is intended for screw driving in wood, metal and
plastic.
For European countries only
Noise
The typical A-weighted noise level determined according
to EN60745-2-2:
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB(A)
Wear ear protection
Vibration
The vibration total
determined according to EN60745-2-2:
Work mode : impact tightening of fasteners of the
maximum capacity of the tool
Vibration emission (a
Uncertainty (K) : 1.5 m/s
EC-DECLARATION OF CONFORMITY
Model; TD090D
We declare under our sole responsibility that this
product is in compliance with the following standards of
standardized documents;
EN60745, EN55014
Directives, 2004/108/EC, 98/37/EC.
000230
Tomoyasu Kato
Responsible Manufacturer:
Explanation of general view
4-1. Reversing switch lever
6-1. Bit
6-2. Sleeve
7-1. Bit
Model
Machine screw
Standard bolt
High tensile bolt
-1
)
Overall length
Net weight
Rated voltage
) : 92 dB(A)
pA
) : 103 dB(A)
WA
value (tri-axial vector
2
) : 10 m/s
h
2
in accordance with Council
CE2007
Director
ENE033-1
Makita Corporation
3-11-8, Sumiyoshi-cho, Anjo, Aichi, JAPAN
Authorized Representative in Europe:
Makita International Europe Ltd.
ENG102-1
Michigan Drive, Tongwell, Milton Keynes, Bucks MK15
8JD, ENGLAND
SPECIFIC SAFETY RULES
DO NOT let comfort or familiarity with product
(gained from repeated use) replace strict adherence
to impact driver safety rules. If you use this tool
unsafely or incorrectly, you can suffer serious
ENG205-1
personal injury.
1. Hold power tools by insulated gripping
sum)
surfaces when performing an operation where
the cutting tool may contact hidden wiring or
its own cord. Contact with a "live" wire will make
exposed metal parts of the tool "live" and shock
the operator.
2. Always be sure you have a firm footing.
ENH102-7
Be sure no one is below when using the tool in
high locations.
3. Hold the tool firmly.
4. Wear ear protectors.
SAVE THESE INSTRUCTIONS.
WARNING:
MISUSE or failure to follow the safety rules stated in
this instruction manual may cause serious personal
injury.
3
7-2. Bit-piece
7-3. Sleeve
TD090D
4 mm - 8 mm
5 mm - 14 mm
5 mm - 10 mm
0 - 2,400
0 - 3,000
155 mm
0.92 kg
D.C.10.8 V
GEB012-2