Britton 2Way Gebrauchsanleitung Seite 7

not too hot before placing the child in the child car seat.
• Security is only guaranteed if the child car seat is fitted in accordance with these instructions.
• Failure to comply with the above instructions will automatically void the warranty and exempt
Britton from any liability.
• Store this car seat in a safe place when it is not being in used. Avoid placing heavy objects on
top of it. Do not allow your child car seat to contact with corrosive substances e.g. battery acid.
NOTICE:
1. This is a "Universal" child restraint .It is approved to ECE Regulation No.44.04 series of
amendments, for general use in vehicles and it will fit most, but not all, car seats.
2. A correct fit is likely if the vehicle manufacturer has declared in the vehicle handbook that the
vehicle is capable of accepting a "Universal" child restraint for this age group.
3. This child restraint has been classified as "Universal" under more stringent conditions as
those which applied to earlier designs which do not carry this notice.
4. lf in doubt, consult either the child restraint manufacturer or retailer.
This child restraint is only suitable if the vehicle is fitted with a type approved 3 point with re-
tractor safety belt, in compliance with standard UN / ECE Regulation No.16 or other equivalent
standards.
1. LIST OF PARTS (Fig. 1)
A – Backrest
B – Chest pad
C – Buckle
D – Chest strap
E – Extra cushion
F – Crotch pad
G – Harness adjuster (under the cover)
H – Positioning handle
I – Harness adjuster strap
J – Belt guide hook
K – Shoulder strap slot
L – Belt clip
M – Harness connector
N – Harness connecting anchor
O – Base
2. USE IN VEHICLE:
WARNING
Please install with the 3-point belt.
The safety belt must be approved to ECE R 16 or a comparable standard.
Can be used if the vehicle seat is equipped with a 3-point belt.
EN EN
7