Battery Charging - Modster PAUL Betriebsanleitung

Manual MODSTER PAUL Pocket Drone
5. Insert the Battery into the Model
Open the battery door the model, insert the battery into the beech in the model (pay attention to correct polarity!). To remove, open the door
and pull the plug of the battery out of the connector. If the model is not used, always remove the battery!

6. Battery Charging

Charge the batteries only on a fireproof base. Never charge the batteries unattended (eg over night)! Disconnect the battery from the charger
and unplug it from the mains after charging.
The controller (transmitter) is equipped with an integrated rechargeable battery. A USB charging cable for the controller is included. Connect
the charging cable to a suitable power source and then connect it to the controller (socket on the left side). The LED charging indicator now
lights up. The battery is fully charged when the LED is extinguished. Please disconnect the charging cable after charging. Observe safety
instructions!
A USB charging adapter is included. Connect it to a suitable power source and connect the flight battery (ensure correct polarity). The LED
lights up red during charging. Once the LED is off, the battery is fully charged and ready for use.
7. Flying Functions
The model works only with completey folded out arms!
18 www.modster.at