Pioneer VSX-832 Bedienungsanleitung Seite 72

> Before Start > Part Names
work
0 You may not receive radio waves due to bad radio wave
conditions. Shorten the distance from the wireless LAN
router or remove obstacles to improve visibility, and try
again. Place the unit away from microwave ovens or
other access points. It is recommended to place the
wireless LAN router and the unit in the same room.
0 If there is a metallic object near the unit, wireless LAN
connection may not be possible as the metal can effect
on the radio wave.
0 When other wireless LAN devices are used near the unit,
several issues such as interrupted playback and
communication may occur. You can avoid these issues
by changing the channel of your wireless LAN router. For
instructions on changing channels, see the instruction
manual provided with your wireless LAN router.
0 There may not be enough bandwidth available in the
band for wireless LAN. Connect using an Ethernet cable.
∫ Remote Controller
0 Make sure that the batteries are installed with the correct
polarity.
0 Install new batteries. Do not mix different types of
batteries, or old and new batteries.
0 Make sure that the unit is not subjected to direct
sunshine or inverter-type fluorescent lights. Relocate if
necessary.
0 If the unit is installed in a rack or cabinet with colored-
glass doors or if the doors are closed, the remote
controller may not work reliably.
∫ Display
The display doesn't light
0 The display may go dim while the Dimmer is working,
and may also turn off. Press DIMMER to change the
brightness level of the display.
72
> Install > Initial Setup
∫ Others
Strange noises can be heard from the unit
0 If you have connected another unit to the same wall
outlet as this unit, this noise may be an effect from the
other unit. If the symptoms improve by unplugging the
power cord of the other unit, use different wall outlets for
this unit and the other unit.
The message "Noise Error" is displayed during Full
Auto MCACC
0 This can be caused by a malfunction in your speaker
unit. Check if the unit produces normal sounds.
The results of Full Auto MCACC give a different
distance to the speakers than the actual distance
0 There may be some discrepancies in the results
depending on the speakers you are using. If this is the
case, make the settings in "System Setup" - "Speaker" -
"Distance" in the Home screen.
DRC function does not work
0 Make sure the source material is Dolby Digital, Dolby
Digital Plus, Dolby TrueHD, or DTS.
> Playback
Advanced Setup | Supplementary Information | Others