Dearating the appliance
Open the water supply.
Start the engine according to the oper-
ating instructions of the engine manu-
facturer.
To dearate the appliance, unscrew the
nozzle and allow the appliance to run
until the water exits in a bubble-free
state.
Switch off the appliance and fit the noz-
zle again.
Operation
Danger
Place the appliance on firm surface.
–
The high pressure cleaner must not be
–
used by children. (Risk of accident on
account of improper use of the appli-
ance).
The high pressure spray generates high
–
levels of noise when the appliance is in
use. Risk of hearing impairment. Al-
ways use proper ear-protection aids
while working with the appliance.
The water jet coming out of the high
–
pressure nozzle causes the gun to re-
coil. Further, an angular spray pipe can
cause additional torque. Hence hold
the spray pipe and gun firmly.
Never direct the water jet on to persons,
–
animals, the appliance itself or electrical
components.
Vehicle tyres/ tyre valves may be
–
cleaned only with a minimum spray dis-
tance of 30 cm. Otherwise, the high
pressure spray can cause damage to
the vehicle tyre/ tyre valve. The discol-
ouring of the tyre is the fhe first sign of
damage. Damaged vehicle tyres are a
source of danger.
Do not spray materials contains asbes-
–
tos or other health-hazardous sub-
stances.
The operator must wear proper safety
–
gear to be protected against the water
sprays.
16
Pay attention to ensure that all screws
–
of all connecting hoses are tightened
properly.
The lever of the hand spray gun must
–
not be locked during the operation.
Do not spray flammable liquids.
–
Turning on the Appliance
Open the water supply.
Start the engine according to the oper-
ating instructions of the engine manu-
facturer.
Press the lever on the hand spray gun.
Select round or flat spray by turning the
casing:
Close the hand spray gun.
Turn the casing to select the desired
spray type.
Meaning of the symbols
High pressure circular spray
(0°) for specially stubborn dirt
Flat low pressure spray
(CHEM) for operating using
detergents or cleaning at low
pressure.
High pressure flat spray (25°)
for large dirt areas
Note
To prevent damage due to too much pres-
sure, always position high pressure ray first
from a greater distance towards object to
be cleaned.
– 4
EN
Triple nozzle