Operating The Device Safely - Waeco CoolMatic HDC-270 Montage- Und Bedienungsanleitung

_HDC270.book Seite 33 Montag, 18. Oktober 2010 8:12 20
HDC-270
NOTICE!
A
Ensure that the ventilation vents are not covered.
Keep the drainage outlet clean at all times.
Check that the voltage specification on the type plate is the
same as that of the power supply.
Do not open the refrigerant circuit under any circumstances.
Set up the device in a dry location where it is protected against
splashing water.
Do not place it near naked flames or other heat sources (heat-
ers, direct sunlight, gas ovens etc.).
Food may only be stored in its original packaging or in suitable
containers.
The appliance is not suitable for the storage of caustic materials
or materials containing solvents.
Disconnect the cooling device and other electric consumers
from the battery before you connect the battery to a quick charg-
ing device.
Overvoltage can damage the electronics of the device.
2.2

Operating the device safely

DANGER!
D
Do not touch exposed cables with your bare hands. This applies
especially when operating the device from the AC mains.
CAUTION!
!
If you connect the appliance to a battery, make sure that no food
comes into contact with the battery acid.
NOTICE!
A
Protect the device from moisture.
Make sure that foodstuffs do not touch the walls of the cooling
area.
Safety instructions
33