Operation; Initial Operation; Switching On And Off; Light - Mafell K 55 cc Originalbetriebsanleitung

5

Operation

5.1 Initial operation

Personnel entrusted to work with the machine must
be made aware of the operating instructions, calling
particular attention
instructions".

5.2 Switching on and off


Switching on: Press the switch-on lock 9 (Fig.
2) forward to unlock it. Then actuate switch
trigger 10 (Fig. 2) when the switch-on lock is
pressed.
As this is a switch without locking device, the
machine will only run for as long as this switch trigger
is pressed.

Switching off: Release switch trigger 10 (Fig.
2) to switch off the machine. The built-in
automatic brake limits the saw blade slowing
time to approx. 1 - 2 s. The switch-on lock
automatically takes effect again and secures the
portable circular saw against accidental switch-
on.

5.3 Light

Caution
Do not stare into the burning lamp!
The power tool is equipped with a light module 21
(Fig. 5).
The light module is supplied with power for a certain
period of time as soon as the machine is switched on,
and is then ready for operation.
When the machine is ready for operation, the light
module automatically switches the light on when the
machine is moved or switches it off when the
machine is standing still for longer periods.

5.4 Cutting depth adjustment

The cutting depth is continuously variable between 0
and 55 mm.
Proceed as follows to adjust it:

Unfasten the clamping lever 12 (Fig. 1).

Set the cutting depth with the plunge lever 13
(Fig. 1).
to the chapter "Safety

The set depth can be read off scale 14 (Fig. 1).
The bevelled edge of the plunge lever serves as
indicator.

Retighten clamping lever 12 (Fig. 1).
Always set the cutting depth
approx. 2 to 5 mm (5/64 to 13/64
in.) larger than the material
thickness to be cut.

5.5 Setting for bevel cuts

For bevel cuts, the saw unit can be set to any angle
between 0 °and 45°.

In order to incline it, bring the machine into
home position and support it such that it is
possible to tilt the saw unit.

Release the lever 15 (Fig. 1).

Adjust the angle according to the scale on the
segment for tilting.

Retighten the lever 15 (Fig. 1) afterwards.

5.6 Plunge cuts

Danger
Risk of backlash during plunge
cuts! Prior to plunging, place the
machine with the rear edge of its
base plate against a limit stop
fastened on the workpiece. Keep a
firm hold on the machine handle
during plunging and push the saw
lightly forward!

Release clamping lever 12 (Fig. 1) and put the
machine in the topmost position with plunge
lever 13 (Fig. 1).

Completely open the retractable saw guard with
the pre-feed lever 16 (Fig. 1), so that the
machine can be placed onto the workpiece to be
processed. The saw blade is now freely
suspended above the material and can be
aligned with the marking.

Switch on the machine and press the plunge
lever 13 (Fig. 1) downwards. This causes the
saw blade to plunge vertically into the
workpiece. While doing so, the plunge depth
can be read off the scale 14 (Fig. 1). The riving
knife/splitter swings up and away when the
-21-