Werbung
Connection to your amplifier
(See the figure inside the front cover.)
Before making connections, make sure that the
amplifier is switched off.
Notes on connections
● Connect the push-type input terminals at the rear of the
speakers to the speaker output terminals of your
amplifier with the provided speaker cables.
● One side of the speaker cable has a white broken line.
Connect the (+) terminals on both the amplifier and the
speakers using the side with a white broken line.
Connect the (–) terminals on both components using the
side with no line.
● Connect one speaker to the left (marked L) terminals of
your amplifier, and the other speaker to the right
(marked R) terminals, making sure not to reverse the
polarity (+, –). If one speaker is connected with reversed
polarity, the sound will be unnatural and lack bass.
● The provided speaker cables have labels marked
FRONT L, FRONT R, CENTER, REAR L or REAR R.
Connect each speaker cable to the corresponding
speaker.
● When using this speaker system connecting with a
multichannel amplifier (RP-U200 etc.), also be sure to
use a subwoofer (YST-SW45 etc.). Moreover, set the
multichannel amplifier or a DVD player etc. which sends
signals to the amplifier in the "small speaker mode". If it
is set in the "large speaker mode", the speakers may
reproduce distorted sounds due to excessive input of low
frequency signals, or the speakers may be damaged.
How to Connect:
1
Press and hold the terminal's tab, as shown in the
figure.
2
Insert the bare wire end properly into the terminal hole.
[Remove approx. 10 mm (3/8") insulation from the
speaker cable.]
3
Release your finger from the tab to allow it to lock
securely on the cable's wire end.
*
Test the firmness of the connection by pulling lightly on
the cable at the terminal.
Notes
● Do not let the bare wires touch each other as this could
damage the speaker or the amplifier, or both of them.
● Insert the speaker cables into the terminal holes securly,
taking care not to let the bare wires touch both (+) and (–)
terminals. If the cables are not inserted securly, it may
cause noises or no sound from the speakers, or damage the
speakers.
● Insert the bare wires only into the terminal holes. If the
insulated (vinyl) part of the cable is inserted, no sound will
be reproduced from the speaker.
● Fix the speaker cables to avoid catching your hands or feet
on the loose cables.
Specifications
Type ............................................ Full range speaker system
Driver ..................................................... 5 cm (2") cone type
Nominal Input Power .................................................. 15W
Maximum Input Power ................................................ 50W
Impedance ...................................................................... 4Ω
Frequency Response ................................. 120 Hz–25 kHz
Sensitivity .................................................................. 82 dB
Dimensions (W x H x D) ........... 70 mm x 95 mm x 118 mm
Weight ......................................................... 0.3 kg (0.6 lbs.)
Accessories
* Please note that all specifications are subject to change
without notice.
3
E-
Magnetically shielded type
(2-3/4" x 3-3/4" x 4-5/8")
Speaker cable (3m) x 3
Speaker cable (7m) x 2
Cable holder x 1
Pad x 20
Fastener x 1
Werbung
