Removing / Attaching The Grille; Specifications - Yamaha NS-P350 Bedienungsanleitung

Removing / Attaching the grille

The grille is attached to protect the speaker unit, but you can remove it if necessary.
To remove the grille, hold on to both sides and slowly pull straight away from the speaker. To reattach, line up the four
holes on the inside surface of the grille with the four corresponding pegs on the speaker and push gently.
Note
• When removing or attaching the grille, be careful not to touch the drive units, and not to exert excessive force with any
tools.
• Do not touch or apply impact to the speaker's diaphragm. Otherwise, the speaker may malfunction.
• To avoid damaging the grille, never apply excessive force, and be sure to use its frame, never pull or push the surface, for
removing or attaching the grille.
■ Center speaker (NS-PC350)
Type.................................................. 2-way Acoustic Suspension
Driver
Woofer: ..............................................13 cm (5") cone type x 2
Tweeter: ................................. 3 cm (1") aluminum dome type
Impedance ............................................................... Nominal 6 Ω
Frequency response ........................... 58 Hz - 45 kHz (–10 dB)
Nominal input power ....................................................... 100 W
Maximum input power .................................................... 200 W
Sensitivity ........................................................ 90 dB/2.83 V, 1 m
Crossover frequency....................................................... 2.8 kHz
Dimensions (W x H x D)
.................................500 x 174 x 202 mm (19-5/8" x 6-7/8" x 8")
Weight ......................................................... 6.3 kg (13 lbs. 14 oz)
* Specifications are subject to change without notice.
* Care should be taken not to exceed the input power values noted above.
NS-PC350

Specifications

Non-Magnetic shielding type
- 100 kHz (–30 dB)
NS-PB350
■ Surround speakers (NS-PB350)
Type.................................................................... 2-way bass reflex
Driver
Woofer: .....................................................13 cm (5") cone type
Tweeter: .................................3 cm (1") aluminum dome type
Impedance ...............................................................Nominal 6 Ω
Frequency response ........................... 57 Hz - 45 kHz (–10 dB)
Nominal input power ......................................................... 50 W
Maximum input power .................................................... 150 W
Sensitivity.........................................................88 dB/2.83 V, 1 m
Crossover frequency .......................................................... 3 kHz
Dimensions (W x H x D)
......................... 186 x 320 x 208 mm (7-3/8" x 12-5/8" x 8-1/4")
Weight............................................................ 4.8 kg (10 lbs. 9 oz)
Non-Magnetic shielding type
- 100 kHz (–30 dB)
5
En