Bluetooth ® Pairing - Hama 123513 Bedienungsanleitung

Note
• To ensure that the keyboard functions
properly, check that the right keyboard
layout (QWERTZ, QWERTY etc.) is set in
your device's settings.
• Note that support for certain key functions
may vary depending on your device.
• If some keys on the Bluetooth
do not work properly on your device for
software reasons, you can run them via
the virtual keyboard.
• Please refer to the operating instructions
for the device you are using.
5. Getting Started
Warning – Batteries
• Immediately remove dead batteries from
the product and dispose of them.
• Only use batteries (or rechargeable
batteries) that match the specified type.
• Do not mix old and new batteries or
batteries of a different type or make.
• When inserting the batteries, make sure
that the polarity is correct ('+' and '-'
markings). Failure to do so could result in
the batteries leaking or exploding.
• Do not charge non-rechargeable batteries.
• Keep batteries out of the reach of
children.
• Do not short circuit batteries/rechargeable
batteries and keep them away from
uncoated metal objects.
keyboard
®
• Open the battery compartment (4), insert two AAA
batteries with the correct polarity and close the
battery compartment (4).
• If the battery charge is low, the Bluetooth/battery
status LED (1) will begin to flash blue during
operation. Replace the batteries immediately as
described above.
6. Operation
Note
• The functions described in this section
are only available for Bluetooth-capable
terminal devices.
• Note that the maximum range for
Bluetooth is 10 metres without obstacles
such as walls, people, etc.
6.1 Bluetooth pairing
®
Note – Pairing
• Make sure that your Bluetooth
terminal device is on and Bluetooth
activated.
• Make sure that your Bluetooth
terminal device is visible for other
Bluetooth devices.
®
• For more information, please refer to the
operating instructions of your terminal
device.
• Slide the [OFF/ON] switch (2) to the ON position
to switch on the Bluetooth
Bluetooth /battery status LED (1) flashes blue.
®
• Press and hold the [CONNECT] button (3) until
the Bluetooth /battery status LED (1) begins to
®
continually flash blue. The keyboard is searching
for a Bluetooth connection.
®
• Open the Bluetooth
device and wait until Hama KEY4ALL X510
appears in the list of Bluetooth
-capable
®
is
®
-capable
®
keyboard. The
®
settings on your terminal
®
devices found.
®
3