Bluetooth ® Pairing - Hama KEY4ALL X300 Bedienungsanleitung

• Open the battery compartment (4), insert two AAA
batteries with the correct polarity and close the battery
compartment (4).
• If the battery charge is low, the Bluetooth/battery status
LED (1) will begin to flash blue during operation. Replace
the batteries immediately as described above.
6. Operation
Note
• The functions described in this section are only available
for Bluetooth-capable terminal devices.
• Note that the maximum range for Bluetooth is 10
metres without obstacles such as walls, people, etc.
6.1 Bluetooth pairing
®
Note – Pairing
• Make sure that your Bluetooth
is on and Bluetooth
®
• Make sure that your Bluetooth
is visible for other Bluetooth
• For more information, please refer to the operating
instructions of your terminal device.
• Slide the [OFF/ON] switch (2) to the ON position to switch
on the Bluetooth keyboard. The Bluetooth
®
LED (1) flashes blue.
• Press and hold the [CONNECT] button (3) until the
Bluetooth /battery status LED (1) begins to continually
®
flash blue. The keyboard is searching for a Bluetooth
connection.
• Open the Bluetooth settings on your terminal device and
®
wait until Hama KEY4ALL X300 appears in the list of
Bluetooth devices found.
®
• Select Hama KEY4ALL X300, follow any instructions on
your terminal device, and wait until the keyboard is shown
as connected in the Bluetooth
device. The Bluetooth
®
• You can now use the Bluetooth
-capable terminal device
®
is activated.
-capable terminal device
®
devices.
®
/battery status
®
settings on your terminal
®
/battery status LED (1) goes out.
keyboard.
®
6.2 Automatic Bluetooth
pairing)
Note
• Make sure that your Bluetooth
on and Bluetooth
• Make sure that your Bluetooth
visible for other Bluetooth
• For more information, please refer to the operating
instructions of your terminal device.
• Slide the [OFF/ON] switch (2) to the ON position to switch
on the Bluetooth
LED (1) flashes blue.
• You can now use the Bluetooth
Note – Connection impaired
After the devices have been paired once, the connection
is then established automatically. If the Bluetooth
connection is not established automatically, check the
following:
• Check the Bluetooth
to see whether Hama KEY4ALL X300 is connected.
If not, repeat the steps listed under 6.1 Bluetooth
pairing.
• Check whether obstacles are impairing the range. If so,
move the devices closer together.
®
6.3 Changing the operating system
The Hama KEY4ALL X300 keyboard supports three different
operating systems. You can use the following shortcut keys to
select the desired operating system:
• fn + Q for Apple iOS
• fn + W for Android
• fn + E for Windows
connection (after successful
®
-capable terminal device is
®
is activated.
®
-capable terminal device is
®
devices.
®
keyboard. The Bluetooth
®
keyboard.
®
settings of your terminal device
®
/battery status
®
®
®