Restore Default Status - Jung FRWM-AR Betriebsanleitung

7 Restore default status

(1) To set the FRWM-AR into default
status, press and hold the configura-
tion button for approx. 20 seconds.
During these 20 seconds, the LED
produces various optical signals at
different intervals:
1
At the start, a continuous
•
yellow interval signal
Then a slowly flashing
•
yellow interval signal
Finally a quickly flashing
•
yellow interval signal
EN
2
20 sec.
Operating Manual: FRWM-AR Alarm Relay
(2) Now release the button
(3) The Status-LED
lights up green briefly
5 The device is now in the default
status .
3
Info:
The default status can only be restored
if the FRWM-AR is in the status that was
given, when the FRWM-AR was integrat-
ed into the radio group/during the learn-
ing process.
Example: When the FRWM-AR was in-
tegrating and the contacts were bridged,
during the reset, the contacts must also
be bridged / the device must be in the
non-alarm status.
4
33