Jung FRWM-AR Betriebsanleitung Seite 31

4.3 Integrating into a radio group
The FRWM-AR cannot be the master
in a radio group. Therefore, to integrate
the FRWM-AR, at least one FRWM must
be in learning mode. Perform the follow-
ing steps to integrate the FRWM-AR:
4.4 Set the FRWM radio
group into learning mode
Start learning mode, if the FRWM
is in its as delivered condition:
f Press and hold the radio button at
the FRWM until the LED lights up
yellow, then release it immediately.
Starting learning mode if the
FRWM is already integrated
into a radio group:
f Press and hold the radio button at
the FRWM until the LED lights up
yellow and wait until it goes out
again. Only then release the radio
button!
EN
Operating Manual: FRWM-AR Alarm Relay
For all further steps, the FRWM-
AR must be in its delivery condi-
tion.
f If this is not the case, follow the
instructions listed under point 7.
"Restoring default state"
on page 33.
(1) Press the configura-
tion button for approx.
1 second
(2) The Status-LED
now flashes yellow for
approx. 5 seconds.
(3) Then the LED lights up
green for approx. 3 seconds.
(4) Finally, the Status- LED
flashes yellow at the same
31