FALMEC GRUPPO INCASSO AP50 600 Bedienungssanleitung Seite 27

H
FILTERS
1. METAL FILTERS
To remove the anti-grease metal fi lters, just act on the specifi c handle. In the perimeter suc-
tion hoods remove the steel panel as indicated in fi g. H1 and then remove the metal fi lters.
2. CHARCOAL FILTERS
To replace the charcoal filters, proceed as follows: remove the metal filters as indicated
above. The two filters hooked on the right and left sides of the conveyor can now be easily
accessed. See figure for assembly/replacement.
Note: gruppo incasso NRS.
To assemble or replace the charcoal filters, see the instructions in the specific optional
charcoal filter kit for each model.
Gruppo incasso filter code kacl. 920.
To order new charcoal fi lters contact the distributor/retailer.
ONLY FOR ITALY: Download the filter order module from the website: www.falmec.com.
I
LIGHTING
1. SQUARE SPOTLIGHT
How to replace a square halogen light:
a) Check that the equipment is disconnected from the power supply.
b) Open the panel completely till 90° (see figure) pressing the PUSH button
c) Replace the lamp with a similar one (halogen, max 20 W, 12 Volt, G4 connection).
d) Close the panel. If the panel does not close correctly repeat the operation at point b.
REMOVING AND REPLACING'S INSTRUCTIONS
ASSEMBLY AND REPLACEMENT
25