FALMEC GRUPPO INCASSO AP50 600 Bedienungssanleitung Seite 26

The function "desired speed" enables to start the motor at the speed that was selected
before the hood was last turned off.
Timer pushbutton
This function allows the automatic turning off of the hood after running for 15 minutes at
the speed previously set (the pushbutton shows a flickering light).
WARNING:
Install the hood away from sources of electromagnetic waves, as these could affect the
correct operation of the electronic system.
Maximum operating distance: 5 metres. The maximum operating distance could be less
than 5 metres in case of electromagnetic interference by other equipment.
Light pushbutton on remote control: light on/off.
– and + pushbutton: increase/decrease speed (to start the motor press either the + or the
– pushbutton).
Timer pushbutton: see instructions below.
RADIO CONTROL OPERATING AT 433.92MHZ.
Technical characteristics:
Power supply
Trans. consumption
Antenna
Oscillating type
Working temp.
By pressing one of the keys the led will illuminate and indicate the transmission of the
code. If the led does not illuminate, the battery may require replacing.
Replacing the battery: open the rear cover and insert the battery respecting the correct
polarity.
ATTENTION! If the battery is replaced with one that is of the wrong type there is the possibi-
lity of an explosion.
When discharging the battery, follow the respective regulations that are currently in force.
The manufacturer
Falmec S.p.A. - Via dell'Artigianato, 42 - 31029 Vittorio Veneto (TV) ITALY
declares that this radio control conforms to all of the technical regulations related to the
product and within the application confines of the directive 1999/5/CE.
All of the necessary radio frequency tests have been performed.
ETSI EN 300 220-2 V2.1.2 (2007-06)
ETSI EN 301 489-1 V1.4.1 (2002)
ETSI EN 301 489-3 V1.4.1 (2002)
INSTRUCTION FOR CHANGING THE FALMEC RADIO CONTROL
only in the case of malfunction due to interferences)
Disconnect the device from the mains.
To enter in the "change code mode" the button "Luce" and "Timer" (remote control) must
be pressed together for more than 3 seconds. After 3 seconds the LED starts flashing
slowly. Now, if you press the button "-" (remote control) within 5 seconds a new code
is generated in casual mode and memorized within the radio control. The memorizing is
confirmed by 3 quick LED flashings.
To get back to the default code: press "-" and "+" (remote control), together for more
than 5 seconds. After 5 seconds, the default code is memorized within the radio control.
The memorizing is confirmed by 3 quick LED flashings. Plug the device to the mains and
check that lights and motors are off. Press the timer button on the push-button panel for 2
seconds and, when the red LED lights up, press any of the radio control's buttons within 10
seconds. With this operation a new transmission code is registered.
24
3V lithium battery (type CR2032)
6mA
incorporated
SAW
-10°C to + 55°C
EN 60950-1 (2001)
EN 50371 (2004-06)
(to be used