Switching Off; Massage Settings/Heat Settings; Cleaning And Maintenance - Beurer FWM 45 Gebrauchsanweisung

4.3 Switching off

To switch the foot warmer off, set the sliding switch for massage and heat settings to the setting "0" (OFF).
NOTE
If the foot warmer is not in use, set the sliding switch to "0" (OFF). Disconnect the mains part from the
foot warmer. Remove the mains part from the socket.

4.4 Massage settings/heat settings

– Massage only: (
Setting I (low): relaxing massage
Setting II (high): invigorating massage
The sliding switch for the heat settings is in the "0"
position.
– Heat only: ( )
Setting I: minimum heat
Setting II: maximum heat
The sliding switch for the massage settings is in
the "0" position.
– Massage with heat: (
Massage and heat setting freely selectable.
– No massage or heat:
Both sliding switches are set to "0".
WARNING
If the foot warmer is being used over several hours, we recommend that
you select the lowest heat setting on the controller to avoid overheating
the feet, which may lead to burns to the skin.

5. Cleaning and maintenance

WARNING
Before cleaning, always remove the mains part from the socket first.
Then disconnect the mains part cable from the foot warmer controller.
Otherwise, there is a risk of damage.
IMPORTANT
• The controller must never come into contact with water or other liquids, as this may cause damage
To clean the controller, use a dry, lint-free cloth. Do not use any chemical or abrasive cleaning agents.
Small marks on the foot warmer can be removed with a damp cloth and, if necessary, with a little liquid
detergent for delicate laundry.
IMPORTANT
• Please note that the foot warmer must not be washed, chemically cleaned, wrung out, tumble dried,
put through a mangle or ironed. Failure to observe this may result in damage to the foot warmer.
The removable fleece lining can be washed by hand.
Use a delicate laundry detergent and measure it out according to the manufacturer's instructions.
)
)
,
11