Initial Use; Switching On; Setting The Temperature; Switching Off - Beurer TS 19 Gebrauchsanweisung

4.2 Initial use

• Spread out the heated underblanket flat onto your mattress starting at the foot end.
• To operate the heated underblanket connect the control to the heated underblanket by
plugging in the connector.
• Then plug in the supply plug into the mains outlet.
• Then put on your bedsheet in the usual manner so that the heated underblanket is
between your mattress and the bedsheet
CAUTION
Make sure that the heated underblanket is spread out entirely flat and that it will not rumple up or
crease when in use.
NOTE:
Lie in comfort
If the plug-in connector at shoulder level bothers you, you
can rotate the electric underblanket by 180° so that the
plug-in connector lies at the foot of the bed (see illustra-
tion). So that the switch is within comfortable reach of
your hand, Beurer offers a switch with a longer connection
cable (Item no. 108.523). This is available directly from
Beurer Customer Services.

4.3 Switching on

To switch on the electric underblanket, set the slider for ON/OFF and temperature settings to setting 1, 2 or 3.
The temperature settings are illuminated when switched on.

4.4 Setting the temperature

Setting 0: OFF
Setting 1: minimum heat
Setting 2: medium heat
Setting 3: maximum heat
NOTE:
• The quickest way to heat up the heated underblanket is to select the highest temperature setting
of the control, first.
• We strongly recommend switching on the heated underblanket approx. 30 minutes before going to
bed and covering it with the quilt to prevent the warmth from escaping.
WARNING
If the heated underblanket is used continuously (for several hours) it is
recommended to use the lowest setting of the control to avoid overheat-
ing of the user.

4.5 Switching off

To switch off the electric underblanket, set the slider for ON/OFF and temperature settings to the OFF (0)
position. The temperature settings are then no longer illuminated.
NOTE:
If the electric underblanket is not used for several days, set the slider for ON/OFF and temperature
settings to the OFF (0) position and remove the mains plug from the socket.
14