Usage; Setting The Temperature; Switching Off - Beurer HK 37 To Go Gebrauchsanweisung

Operating the heat pad
• Pull the heat pad over your head. Ensure that the drawstring (6) is positioned
at the top, facing the front. Ensure that the heating element is located at
your neck.
• To adjust the size, you can pull on the drawstring (6).
• Place the charged powerbank (4) into the built-in pocket (5) on the heat pad.
• Insert the connector plug of the heat pad's connecting cable (3) into the
connection socket on the powerbank. The LED display of the On/Off but-
ton (2) on the heat pad briefly lights up white three times. The heat pad is
now ready for use.
IMPORTANT
Ensure that the heat pad will not bunch up or become folded dur-
ing use.

7. Usage

Switching on
• Press the On/Off button (2) to switch on the heat pad (1). The LED display of the On/Off button lights up
green (minimum heat). The LED display of the powerbank (4) lights up or flashes white according to the
charge status of the powerbank.
• If you press the On/Off button again, the temperature setting will increase (medium heat). The LED display
of the On/Off button lights up yellow.
• If you press the On/Off button again, the heat pad switches to the maximum temperature setting (maximum
heat). The LED display of the On/Off button lights up red.
• If you press the On/Off button again, the heat pad switches off. The LED display of the
On/Off button goes out immediately and the LED display on the powerbank goes out after a few seconds.
WARNING
If the heat pad is being used over several hours, we recommend that
you set the lowest temperature setting to avoid overheating the heated
body part, which may lead to burns to the skin.
NOTE
When the powerbank (4) has been almost completely run down, the heat pad is switched off
automatically to protect the powerbank. The powerbank must then be charged.

Setting the temperature

OFF: On/Off button (2) not lit
Setting 1: Minimum heat (LED display of the On/Off button lights up green)
Setting 2: Medium heat (LED display of the On/Off button lights up yellow)
Setting 3: Maximum heat (LED display of the On/Off button lights up red)

Switching off

Press the On/Off button (2) to switch off the heat pad (1). The switching sequence is 1 - 2 - 3 - OFF ... If the
heat pad is switched off, the LED display of the On/Off button goes out immediately and the LED display on
the powerbank (4) goes out after a few seconds.
NOTE
Please note that the powerbank (4) must be protected against extreme cold to maintain its full
performance.
17