Setting Up The Grill - tepro Vista Bedienungsanleitung

7� Attaching the fire bowl to the stand
column and inserting the charcoal
plate
Place the completely
fire bowl with windshield on top of
the stand column with the open side
pointing forward (same position as the
ash drawer and ventilation controller)�
The lower retaining plates on the fire
bowl must sit inside the stand column
(NOT outside of it!)� It is possible the
plates will have to be bent a little with a
pair of pliers so that they sit inside the
stand column� Fix the fire bowl in place
on the stand column using four screws
and nuts� Finally, tighten all of the
screws and nuts on the fire bowl and
on the windshield� Place the charcoal
plate (5) in the middle of the fire bowl�
8� Putting the BBQ grate in place
Hold the BBQ grate (4) by the handles
and place it on the mounting recesses
in the windshield at the desired height�
assembled
Two different heights are available� The
BBQ has been completely assembled�
Important: Tighten all screws�

Setting up the grill

Attention Risk of damage!
– Check that all screws are tightened
before use� If necessary, tighten all
screws to guarantee stability�
• Before use, place the BBQ on an even,
sturdy surface outdoors�
During use, the screws can
loosen slowly and impair the
grill's stability�
t
21