Setting Up The Grill; Before Grilling; Operation - tepro DETROIT Bedienungsanleitung

t

Setting up the grill

Attention Risk of damage!
During use, the screws can
loosen slowly and impair the
grill's stability.
– Check the stability of the screws prior
to each use. If necessary, tighten all of
the screws again to ensure the BBQ is
standing securely.
• Before use, place the grill on an even,
sturdy surface outdoors.

Before grilling

• Prior to first use, wash the cooking grate
with warm soapy water.
• Pre-firing
Before you use the grill for the first
time, it needs to be conditioned (pre-
fired) for at least 30 minutes at a tem-
perature of 100° – 200°C.
This is necessary in order to make the
inside ready for barbecuing and to burn
in the heat-resistant paint on the out-
side.

Operation

Danger Risk of burning!
The BBQ, the charcoal and
BBQ meat become very hot
during use. Any contact can
result in serious burns.
– Keep sufficient distance from the hot
parts, since any contact can lead to se-
vere burns.
– Always wear oven or BBQ gloves when
grilling. (Glove Category II with regard
to heat protection, e.g. DIN-EN 407)
22
P170051_TEPRO_1037_Detroit_K_DE_GB_20170824.indb 22
All manuals and user guides at all-guides.com
– Use only long-handled utensils with
– Do not wear any clothing with wide
– Use only dry lighters or special fluid
1. Open the cover and remove the
2. You can use both sides or just one
3. Layer maximum 3 kg of charcoal
4. Prior to first use, the grill must be pre-
5. As soon as the charcoal is glowing,
6. Slide the grate onto the guide rails on
7. Place the food to be grilled on the
heat-resistant grips.
sleeves.
lighters compliant with EN 1860-3 as
firelighters.
grates (5).
side of the grill body (8). Place 3-4
solid firelighters in the middle of the
grill body side that you wish to use.
Pay attention to the manufacturer's
instructions on the packaging. Light
the firelighters with a match.
around the firelighters.
fired for minimum 30 minutes. Refer
to the "Before Grilling" section.
distribute it evenly in the grill body (8).
To do this, use a suitable fireproof
tool with a long, fireproof handle.
the windshield at the desired height.
grateonly when the charcoal is co-
vered with a bright layer of ash.
24/8/2017 3:32 PM