Troubleshooting; Possible Cause - Holzmann TS 250F Betriebsanleitung

15

TROUBLESHOOTING

Disconnect the machine from the power supply prior to any checks performed at the
machine itself !
Trouble
Machine does not start
Burn marks on the work-
piece
The finished size of the
machined workpiece does
not correspond to the set
cutting width on rip fence
Workpiece clamped
advancing
HOLZMANN MASCHINEN GmbH

Possible cause

 Emergency stop switch to
switch off
 switch is broken
 The blade is blunt
 Adjusted measurement
scale for the cutting width
display
in  dull blade
 Riving knife thickness does
not match the used blade
www.holzmann-maschinen.at
TROUBLESHOOTING
Solution
 Turn the emergency OFF
switch to the right to unlock
to
 Repair the the switch
 Replace the blade
 Setting dimension scale:
workpiece on the rip
measure the workpiece and
the measuring scale move
so that the measured aver-
age width is shown at the
edge of the ruler
 Replace with sharp blade
 Splitting wedge thickness
must be greater than or
equal to blade thickness.
cut
fence,
61
TS 250F