Screw On The Motor - Holzmann TS 250F Betriebsanleitung

14.2.7 screw on the motor

The motor is mounted in the reverse manner as during dismantling
 Relax by the height adjustment, the drive belt
tension by 3 - 4 turns to the right
 Turn the flange nut with the threaded hole up-
wards.
 Slightly Screw the upper right screw and washer.
-Arrow-
 Put the motor with the motor plate carefully in
the screw hook up.
 Make sure that the drive belt is not clamped.
 Screw the 2 remaining screws
 Tighten all 3 screws slightly.
 The flange bolt with washer and spacer ring into
the Flange Screw.
INFO: Making sure that the brass ring loosely in
the elongated hole is introduced!
.1.1
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
MAINTENANCE AND CARE
flange nut
59
TS 250F