Install New Drive Belt And Drive Shaft; Mounting On The Motor Bracket - Holzmann TS 250F Betriebsanleitung

14.2.5 Install new drive belt and drive shaft

The drive belt and the drive shaft is mounted in the reverse manner as during dismantling
Remove the remains of a worn drive belt from
the pulley.
INFO: Put on the bearing seats lightly oil.
The drive shaft 2 with the flattened sides
-circled- carefully into the seat also matching the
pulley insert.
 pat in with mallet totaly
 Place the disc onto the drive shaft.
 Thighten the nut by drive shaft and hold with a
wrench on the other side.
INFO: When tightening always make for smooth
running of the drive shaft.

14.2.6 Mounting on the motor bracket

The motor bracket is mounted in the reverse way as during disassembly again
 Insert the motor mount to the left in the guide.
 Insert right on top of the screw and screw the
self-locking nut, but do not fully tighten! -Arrow-
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
MAINTENANCE AND CARE
disc
nut
58
TS 250F