Installation Of The Rip Fence Rail; Assembly Of The Rip Fence - Holzmann TS 250F Betriebsanleitung

ASSEMBLY
Tighten the eight screws, keep in mind that the extra table is mounted at the same height as the
main table.
NOTE: Raise the table never without help! Always pay attention to the correct lifting posture!

12.2.9 Installation of the rip fence rail

To install the rip fence rail requires the following:
Four M8x25 screws, four washers 8mm, Four M8 self-locking
nuts
Screw the rail acc. The following diagram on the main table
firmly, making sure that the track runs parallel with the ta-
ble.

12.2.10 Assembly of the rip fence

The handle clockwise to the holder screw.
The holder and the ruler with two allen screws M8-12 screw.
The rip fence is now being used in the stop rail.
If the ruler does not slide smoothly, the stop rail can be ad-
justed.
The rip fence can be fixed at the desired position by a lever
movement downwards.
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at 49
TS 250F