Tension Drive Belt; Mount Saw Blade; Cleaning; Disposal - Holzmann TS 250F Betriebsanleitung

14.2.8 Tension drive belt

Insert a screwdriver or similar tool between the
engine mount and shaft against fire back up
when clamping down.
By the hand wheel turn to the left of the drive
belt is tensioned.
 The handwheel as far to the left until a resitance
is felt.
INFO: On the drive shaft to the blade side, the
tension can be checked by turning.
 After tightening the 3 screws tighten on the mo-
tor plate.
CAUTION: remove the screwdriver after tension-
ing!

14.2.9 mount saw blade

The saw blade is mounted in the reverse manner as during disassembly again.
CAUTION: Check smooth running of the saw blade
Screw the covers back

14.2.10 Cleaning

The use of solvents, harsh chemicals or abrasive cleaners leads to damage to the machine!
Therefore: When cleaning water and mild detergent if necessary use.
Bare surfaces of the machine against corrosion impregnate ( with anti-rust
WD40 )

14.2.11 Disposal

Do not dispose of the TS 250F in residual waste. Contact your local authorities for
information regarding the available disposal options. When you buy at your local
dealer for a replacement unit, the latter is obliged to exchange your old
HOLZMANN MASCHINEN GmbH
N O T E
www.holzmann-maschinen.at
MAINTENANCE AND CARE
60
TS 250F