Mounting The Saw Blade Guard; Connection Suction; Electrical Connection; Earthing Connection - Holzmann TS 250F Betriebsanleitung

12.2.11 Mounting the saw blade guard

Assemble the blade guard (a) to the riving knife (b)

12.2.12 Connection suction

1. Dust collection ports are located on the chip case and blade
guard.
2. Fit the small ejection tube on blade guard.
3. From the hole of table saw rear panel, pull out the chip
ejection tube.
4. Fit the chip ejection tube onto three-way tube.
5. Fit the chip ejection tube of blade guard on three-way tube.
6. Then fit the main chip ejection tube to Dust collector.
Please note that the prosecution is only recommended outdoors without using a suction system.
In addition, without the required suction removal of chips can not be guaranteed and must there-
fore, after every 30min Operating be cleaned (particularly inside the machine), the machine
chips.
12.3

Electrical connection

12.3.1 Earthing connection

When working on an ungrounded machine:
Serious injury due to electric shock in the event of a malfunction possible!
Therefore:
Machine must be grounded and be connected to a grounded outlet
The electrical connection of the machine is ready for operation on a grounded electrical outlet!
The plug must be connected only to a properly fitted and grounded electrical outlet!
The supplied plug must not be changed. If the plug does not fit or is defective, only a qualified
electrical engineer may modify or replace these plugs!
The grounding conductor is green-yellow!
In the event of repair or replacement of the grounding conductor must not be connected to an
under voltage can!
Check with a qualified electrician or service that the grounding instructions are understood and
the machine is grounded!
A damaged cable must be replaced immediately!
HOLZMANN MASCHINEN GmbH
A T T E N T I O N
www.holzmann-maschinen.at
ASSEMBLY
50
TS 250F