Seca 899 Bedienungsanleitung Seite 19

Connecting the connecting cable to the weighing platform
The connecting cable of the display part is used to transmit digital data which are consid-
erably less sensitive to interference than the otherwise conventional small analog meas-
uring signals. Ageing and wear on the cable and on the plug contacts thus have no effect
on the accuracy of the scale.
To make the connection, proceed as outlined below:
– Connect the cable of the display case to
the socket under the carrying handle.
– Then place the scale upright again.
The cable may not contact the weighing
platform during weighing, as this might
falsify the result.
4. Setting up and aligning the scale
The screwed feet can be used to level off
any slight unevenness in the floor.
– Place the scale on a level surface.
– Align the scale by screwing the foot
screws. The air bubble in the spirit level
must be right in the centre of the circle.
– Ensure that only the feet of the scale are
in contact with the floor. The scale may
not be in contact at any other point.
Model 899
spirit level
19
GB