WimTec Santec ECOLINE 9 V Montage- Und Bedienungsanleitung Seite 30

EN
Configuring the functions
Continuous flow for thermal disinfection:
Program 5 und 6
For thermal disinfection, a continuous flow for 10 minutes can be triggered.
!
Note:
In order to provide thermal disinfection must
Be set to hot water lever mixer and a temperature
of min. 65 ° C can be achieved.
Enable thermal disinfection
Approach the infrared sensor
with your hand. The sensor
LED starts flashing. After
flashing five times, the ther-
mal disinfection is enabled.
30 Washbasin fitting
ECOLINE
Protection from scalding
If a user is detected in the ac-
tive region during the thermal
disinfection, the water flow is
stopped and the fitting goes
into the safety stop mode.
After 3 min, the valve swit-
ches to normal operation.
Achieved by introducing the
hand and linger until the LED
Flashes 3 times, the safe-
ty stop can be deactivated
prematurely.
5 x
SanTec ECOLINE
Disable thermal disinfection
After 10 min the water flow
stops, the thermal disinfec-
tion is completed, and the
fitting will resume normal
operation.
10 min