LEITZ complete Bedienungsanleitung Seite 5

Intended use
This Leitz product is intended to be used as a device for reproducing and transmitting
audio sound and for charging devices that can be charged using a USB connector.
This product is intended for private, non-commercial use. The product should only be
used in household or similar environments, such as in offices and shops. The
product should not be used in locations with the presence of a corrosive or explosive
atmosphere or for medical purposes. The product may only be used according to the
instructions as described in this manual. All use other than described in this manual
is seen as unintended use. Modifications in the course of technological progress are
reserved. In these user instructions the Conference Speaker and Power Bank is
referred to as 'speaker'.
Technical specifications 
Material housing: Aluminum/ABS
Battery type: Li-ion battery
Ambient conditions for operation/
storage: 0°C~40°C; 10 %~95 % relative
humidity
WARNING! Read all safety
warnings and all instructions.
• Please take the time and read the
general safety instructions. You can
find the general safety instructions
in a separate booklet. This booklet
is included.
• If the product is not installed and
used in accordance with this
manual, it may cause harmful
interference with radio or television
reception or affect other electronic
devices in residential areas. Use
only shielded cable to connect the
components in order to avoid such
interference. Non-
compliance invalidates the per-
mission to operate this product.
• The integrated Li-ion battery is
flammable. Keep away from open
flame!
• Keep the speaker at a safe distance
from your ears to prevent the risk of
hearing loss.
Unpack and check the contents 
A Portable conference speaker and
power bank
B Micro-USB <> USB-A male cable
C Micro-USB <> AUX IN male cable
D Strap
E Protection sleeve
F Instructions for use and safety
instructions
Use
How to charge the speaker 3
• Before first use, the speaker must
be fully charged (approx. 2 hours).
• Always charge the speaker every 6
months or when only one LED of
the charge level indicator P is
blinking.
• When using a USB power adapter,
make sure to put it into a suitable
and easily accessible mains power
socket.
• It is not possible to use the speaker
as both charger and speaker at the
same time.
1. Make sure the speaker is switched off
(the LED on grill H is off).
2. Use the cable B to connect the
micro-USB connector N to the USB
port of a computer or to an optional
USB power adapter.
->The charge level indicator P
shows the charging progress 4
3. Remove the charger when charging is
complete (4 LED's are steadily lit).
EN 1