Hendi PROFI LINE 210000 Gebrauchsanweisung Seite 6

Problem
Problem
Appliance does not slice well
Appliance stops slicing
Carriage does not slide
Blade stops when product is
being cut
When in doubt, always contact your supplier!
Sharpening the blade
Sharpen the blade when it becomes blunt. The blade
is extremely resistant to wear. If used regularly and
properly, it should only need to be sharpened once
a year.
• Pull the plug from the wall socket.
• Turn the thickness dial to "0".
• Clean the blade.
• Unscrew the sharpener's locking knob.
EN NL
• Lift the sharpener from the locking device and turn
it 180°.
• Both sides of the blade should have 1 sharpening
stone.
• Lower the sharpener until it slips back into the
locking device.
• Fix the sharpener in place by tightening the lock-
ing knob.
• Switch on the appliance. The blade will start to
turn.
• Use the button to press the tilted sharpening stone
Technical data
AC power supply 230-240 V~ 50 Hz
Power
Blade diameter
6
Possible cause
Blunt blade
Dirty appliance
Overheated motor
Dirty slide bar
v-belt worn out or dirty
210017 - 300mm 210000 - 250mm
230-240 V~ 50 Hz
420 W 320 W
300 mm 250 mm
Solution
Sharpen blade
Clean the appliance
Let the machine cool off for an
extended period. The motor's
safety thermostat will reset itself
automatically.
Clean the slide bar and lubricate
with Vaseline
Replace or clean the v-belt
against the blade and keep it there for 2 minutes.
The sharpening stone should turn along with the
blade.
• Use the button to press the vertical sharpening
stone briefly against the blade to remove burrs.
The sharpening stone should turn along with the
blade.
• Switch off the appliance and pull the plug from the
wall socket.
• Unscrew the sharpener's locking knob and clean
the sharpening stones with alcohol.
• Replace the sharpener in its original position on
the appliance and tighten the locking knob to fix it
in place. The blade must not extend between the
sharpening stones.
• Clean the blade with alcohol. WARNING! The blade
is extremely sharp.
• Push the plug in the wall socket.
• The appliance is ready for use.
210048 - 220mm
230-240 V~ 50 Hz
280 W
220 mm
210031 - 195mm
230-240 V~ 50 Hz
200 W
195 mm