Key Functions; Start-Up; Programme Overview; Basic Information - Beurer EM 40 Gebrauchsanleitung

Accessories:
• 1x connection cable (with 2 separately controllable channels, recognisable by
their difference in colour)
• 4x adhesive electrodes
(45 x 45 mm)
• 1x belt clip

4.2 Key functions

Every time a key is pressed, this is acknowledged by a signal tone in order to
ensure that any unintentional pressing of a key is detected. This signal tone
cannot be switched off.
ON/OFF
(1) Hit briefly to switch on the machine. If the key is held down for 10 seconds
when switching on, the unit automatically switches off again.
(2) Press once to interrupt stimulation treatment = pause mode.
(3) Hold ON/OFF key down (approx. 3 seconds) to switch off the machine.
and
(1) Select between (A) treatment programme, (B) frequency and (C) treatment
time.
(2) The DOWN key is used to reduce pulse intensity for both channels during
stimulation.
MENU
(1) Navigation between the submenus TENS, EMS and MASSAGE.
(2) Return to (A) programme selection window or (B) main menu.
ENTER
(1) Menu selection.
(2) To confirm a selection made with UP/ DOWN, apart from channel intensity.
CH1+, CH1-, CH2+, CH2-
Setting pulse intensity.

5. Start-up

1. Remove the belt clip from the machine, if attached.
2. Press on the battery cover at the back of the machine and push it to the side.
3. Insert three AAA 1.5 V alkaline batteries. Make absolutely sure that you
insert the batteries with the correct polarity as marked.
4. Replace the battery cover carefully (Fig. 1).
5. Attach the connecting cable to the electrodes (Fig. 2).
Note: The electrodes have a clip fastener to ensure easy
connection.
7. Insert the connecting cable connector into the socket at the
back of the machine. (Fig. 3)
Note: To ensure optimal durability, remember the following
procedure:
a) attach b) press firmly

6. Programme overview

6.1 Basic information

The Digital TENS/EMS unit has a total 50 programmes:
• 20 TENS programmes
• 20 EMS programmes
• 10 MASSAGE programmes
With all programmes, you can set the length of application and (for each of
the two channels) pulse intensity separately.
Besides this, with TENS and EMS programmes 11-20, you can also change the
pulse frequency of the individual cycles in order to adapt the stimulation effect
to the structure of the site of application.
Cycles are the different sequences making up the programmes. They automatically
run one after the other and increase the efficacy of stimulation on different types
of muscle fibre and combat premature muscle fatigue.
You will find the standard stimulation parameter settings and information on
placing the electrodes in the following programme charts for TENS, EMS and
Massage.
21
Fig. 1
c) detach
Fig. 2
Fig. 3