Herunterladen Inhalt Inhalt Diese Seite drucken
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 1

8. Commissioning

Before you start spraying work, prepare the coating material in line with the manufacturer's instructions (thinning/stir-
ring).
Insert the suction pipe into the material container and switch on the device. Then turn the pressure regulator knob
clockwise until the device starts to run and the system is vented (paint escapes from the venting hose).
As soon as paint starts flowing from the venting hose, hold the gun in a second bucket in which the solution is colle-
cted. Actuate the trigger on the gun and close the venting valve. Turn the pressure regulator switch a bit further and
wait until paint escapes from the gun. The system is now vented.
Release the trigger on the gun; secure it and fit the nozzle holder and nozzle. Gradually turn the pressure regulator
(approx. 10 bar) until the desired spraying pressure has been reached. This is the case when the spraying pattern is free
of stripes. Excessive spraying pressure unnecessarily creates paint mist.
Adjusting the pressure
Risk of injection: never hold your hand, your body, your finger or your hand wrapped in a cloth in front of the spraying
nozzle if you are cleaning the spraying nozzle or checking for blockages. Always point the gun at the floor or a waste
bin if you want to check whether the nozzle is free
During spraying into a paint can, always select the lowest spraying pressure and make sure that one metal part of the
gun always has contact with the metal container.
In case of emergency, switch off the spraying device. If you want to interrupt operations with the device in case of
emergency, switch off the motor. Read the depressurisation section.
Turn the pressure regulator button clockwise to increase the pressure or anti-clockwise to reduce the pressure. Always
use the lowest pressure required for full atomisation of the material. If more material output is required, use a larger
nozzle rather than increasing the pressure.
NOTE:
If you operate the spraying device at a higher pressure than needed, this will lead to increased use of material, and
increased wear on the device and nozzle.
NOTE:
Check the spray pattern. The nozzle size determines the width and flow rate of the coating material.
Storage
Short term storage
Flush the device as described in the chapter "Flushing". Finally, flush the device with the "Coro-Check" preservation
fluid provided (Art. no. 69 09 10) (approx. 100 ml. to approx. 2 - 3 l water) and relieve the mixture through the gun
out of the pump. Coro-Check prevents the valves in the device from sticking. Keep the ventilation/pressure relief valve
closed.
Long-term storage
In this case, flush the device with a mix of oil and turpentine.
Commissioning after extended storage:
Before using water-based paints, first flush the spraying device with soapy water and then with clean water. If you will
be using the device with oil-based paints, flush out the spirit solvent with the coating material.
140

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis