Miditech MIDI THRU 4/ FILTER Bedienungsanleitung Seite 27

flashes, to show that you are now in "setup mode" .
2. Set switch 6 to ON
3. Press keyboard, a white key is for set filter Pitch Bend, a
black key is for filter Aftertouch, if you press both white and
black keys, filter both.
4. To confirm the changed setup, press the Panic button a short
time again. After this the box starts again with the work mode.
E.g.
Press a white key, then the system set filter Pitch Bend flag.
If not press black key later, the After Touch filter flag will not
set.
How to select filter MIDI system message type:
1.Hold down and press the PANIC button minimum 5 Seconds
while plugging the MIDI In to power the system. The LED
flashes, to show that you are now in "setup mode" .
2. Set switch 7 to ON
3. Press keyboard, a white key is to filter System Exclusive
Messages. a black key is to filter Common Messages, if you
press both white and black keys, filter both.
If you specify to filter the Sys Ex events, e.g. the table is 41H,
00H, 42H, 12H, 40H, (all Roland GS SysEx start from these
bytes). If MIDI IN a GS Reset SysEx: F0H, 41H, 00H, 42H,
12H, 40H, 00H, 7FH, 00H, 00H, F7H, it match the filter table,
27