Miditech MIDI THRU 4/ FILTER Bedienungsanleitung Seite 22

"Setup mode" and "Work mode"
To setup the MIDI THRU 4 /FILTER, you must enter the
"setup mode". Hold down and press the PANIC button
minimum 5 Seconds while plugging the MIDI In to power
the system. The LED flashes, to show that you are now in
"setup mode" .
Now you can program the Switches. The last setup will be
stored in the MIDI THRU 4/FILTER box.
To exit this mode, and go back to the working mode, please
press the PANIC button once again a short time. This is
NECESSARY to confirm the new settings.
In Setup mode, if you disconnect the MIDI IN cable, the
MIDI THRU 4 / FILTER box looses power and after re-
connecting, it starts again with the old unchanged settings.
You need to confirm new settings by pressing the Panic
button a short time again.
The "work mode" – you are always in the "work mode" after
booting. If you have all DIP switches set to OFF, except the
Switch 3 should be ON to keep the MIDI velocity active, the
MIDI THRU 4 / Filter box will work only as a MIDI Thru
box without filter functions.
To reset all DIP switch and controller filter settings, hold
down and press the PANIC button while powering on the
MIDI THRU 4/Filter box minimum 10 seconds. The LED
will give a stable light to show the reset of the filter box.
22