Miditech MIDI THRU 4/ FILTER Bedienungsanleitung Seite 23

How to re-map the MIDI channel:
1. Hold down and press the PANIC button minimum 5 Seconds
while plugging the MIDI In to power the system. The LED
flashes, to show that you are now in "setup mode" .
2. Set switch 1 to ON, all MIDI message should modify the
channel as preset channel.
if switch 1 is OFF, don't modify channel
3. Press keyboard, the key C5 is channel 1, next key C#5 –
channel 2.. and so on.
C5 – channel 1
C#5 – channel 2
D5 - channel 3
D#5 – channel 4
E5 – channel 5
F5 – channel 6
F#5 – channel 7
G5 – channel 8
G#5 – channel 9
H5 – channel 10
C6 – channel 11
C#6 – channel 12
D6 – channel 13
D#6 – channel 14
E6 – channel 15
F6 – channel 16
4. To confirm the changed setup, press the Panic button a short
time again. After this the box starts again with the work mode.
23