Miditech MIDI THRU 4/ FILTER Bedienungsanleitung Seite 24

How to set transpose preset:
1. Hold down and press the PANIC button minimum 5 Seconds
while plugging the MIDI In to power the system. The LED
flashes, to show that you are now in "setup mode" .
2. Set switch 2 to ON
3. Press keyboard, the key C4 is transpose 0, next higher key is
transpose +1, etc. You can step up and down to set the
Transpose in a maximum of +/- 2 octaves.
For example:
C#5 – Transpose +1
D5 – Transpose +2
D#5 - Transpose +3
and so on.
Also downwards:
H4 – Transpose -1
B4 – Transpose -2
A4 – Transpose -3
and so on.
4. To confirm the changed setup, press the Panic button a short
time again. After this the box starts again with the work mode.
How to set velocity preset value:
1. Hold down and press the PANIC button minimum 5 Seconds
while plugging the MIDI In to power the system. The LED
flashes, to show that you are now in "setup mode" .
24