Use And Maintenance - Baumann AURA Montage- Und Bedienungsanleitung

First of all, mark your ceiling by a pencil before drilling, according to the sizes at "Figure A" and set the
hood mains cable outlet will be from the top or from the side, depending on your wall plug place according
to "Figure B and Figure C"
ELECTRIC WIRING
The electrıc wiring must be performed by a specialized electrician fully respecting current standards and
legislation in force. Check that the power supply corresponds to the voltage requested by the hood,
which is given on the silver label stuck inside the hood. Ensure that the wiring system conforms to current
standards and the earth discharge works efficiently. Pay special attention to the hood power cable, ensure
that it does not pass through any holes without a cable clamp. For direct connection to the electrical mains
is necessary to provide a device that ensures disconnection from the electrical mains, with an opening
distance of the contacts that allows the complete disconnection under the conditions of overvoltage
category III. in accordance with the rules of installation
The plug or omni polar switch must be accessible when the unit is installed.
If the power cord is damaged, it must be replaced by a special cord or assembly available from the
manufacturer or its service agent. The cable used must be of type H05VV-F3X0.75 mm2 minimum cross-
section.
The manufacturer declines all responsibility if the current accident prevention standards in force are not
respected, which are needed for the wiring system to operate correctly
CONTROLS
DIGITAL TOUCH CONTROL
There are five digital touch buttons and a display.
> One button for turning on at 2nd speed and for turning the motor off.
> Two button + and – for increasing and decreasing the motor speed.
> One button for turning the lights on and off.

USE AND MAINTENANCE

Before beginning any sort of cleaning or maintenance work, turn power off to the hood by turning
the main switch to 0 (OFF).
Changing the light bulbs
LED bar light replacement should only be carried out by qualified technicians using only original spare
parts. "Figure D"
Cleaning the metal filters:
The metal filters fitted in the hood should be washed every 2-3 weeks, depending on how much the
hood is used, using hot water and a liquid detergent that is not too aggressive. The metal filters can be
removed by the special handle, unhooking the front part of the filter and pulling it downwards. Check
"Figure E"
Electrostatic odor, smell removal system.
Your hood is equipped with a patented odor, smell removal system. As you turn on the hood the
system starts to work with the motor and when you turn off the hood, it stops simultaneously. For best
efficiency, turn on the hood as soon as starting to cook and leave it working for about 30 minutes
(depending on the kitchen size) to remove the odor from your kitchen after your cooking is finished.
When the odor is removed turn off the hood. This system is integrated in to the upper motor box of the
hood covered all around by a special active carbon impregnated filter for extra odor cleaning efficiency.