Overheating Protection; Status Led - Phottix Mitros+ Benutzerhandbuch

To use:
1. Align the diffuser with the flash head, with the "UP" mark on the diffuser
facing up.
2. Snap one side of the diffuser mount into the corresponding flash head
mount.
3. Repeat step 2 on the other side of the diffuser.

Overheating Protection

The Phottix Mitros+ contains an overheating protection circuit that will slow
flash recycle times to avoid overheating-related damage. Continuous full-power
flashes in a short amount of time will trigger this protection. The flash recycling
time will become slow and a [Hot! ] icon will appear when the overheating pro-
tection circuit is in operation.
To avoid further overheating or possible damage the flash will increase the re-
cycling time to assist in lowering the flash temperature. Wait 10 minutes before
reusing the flash.
If the flash continues to be used after the [ Hot! ] Icon appears and the flash
does not cool down a [ Stop ] icon will appear on the LCD. Cease using the flash
immediately and wait 10 minutes for it to cool down.
Sync and USB Ports
1. The 3.5mm Sync Port can be used with a 3.5mm sync cable to trigger the
flash-from a flash trigger or camera. This port is input only – flash signals cannot
output from this port.
2. The USB port is used for firmware upgrades. Firmware announcements and
instructions will be made available on Phottix websites.

Status LED

Left LED: Flash-ready indicator. In Quick Flash Mode, the LED will flash green
when the flash has the minimum recycle charge. It will flash red when fully
charged.
Right LED: Flash exposure confirmation lamp. If a standard flash exposure is
obtained, the flash exposure confirmation lamp will light blue for approximately
3 seconds. If the flash exposure confirmation lamp doesn't light, move closer to
the subject or increase the camera ISO setting.
4
INSTRUCTION MANUAL
En