Product Description And Specifications; Practical Advice; Technical Data - Bosch PTC 470 Originalbetriebsanleitung

OBJ_BUCH-2139-002.book Page 16 Friday, January 15, 2016 4:17 PM
16 | English
Safety Warnings for Tile Cutters
 Use the tile cutter only for cutting the materials listed
under Intended Use. Marble or granite as well as tiles with
a rough surface structure and natural stone tiles cannot be
cut.
 Keep your fingers clear of the movable parts of the tile
cutter. Danger of fingers being crushed or contused and
considerably injured.
 Wear protective gloves when cutting tiles. Sharp edges
develop on broken tiles and can cause injuries to the oper-
ator.
 When transporting the tile cutter, use only the handles,
tighten all loose components (fences, rulers), press
down the locking lever to lock the guide rail, and fix the
transport safety-lock (see figures 15 and 16). There is a
risk of injury if it falls down.
Product Description and Specifica-
tions
Intended Use
The tile cutter is intended for cutting ceramic tiles.
Product Features
The numbering of the product features refers to the illustra-
tions on the graphics pages.

Practical Advice

Problem Cause
Tile does not break Too much pressure applied when scoring the
cleanly tile (e.g. on "soft" tiles such as wall tiles or
glazed tiles)
There is tile debris under the spring-mounted
supporting surface 6
Tile already breaks when Too much pressure applied when scoring the
scoring tile (e.g. on "soft" tiles such as wall tiles or
glazed tiles)
Tile does not break along Not enough pressure applied when scoring the
the cutting line tile (e.g. on "hard" tiles such as fine stoneware,
floor tiles or frostproof tiles)
Guide rail 4 not locked
Cutting wheel 3 blunt
Tile breaks incorrectly Breaking stamps 2 not applied at the end of the
when making a parallel tile
cut
Tile breaks incorrectly Breaking stamps 2 applied at the end of the tile Apply breaking stamps 2 slightly ahead of
when making a diagonal
cut
Tile not stable on the Tile is wider than the supporting surface 6
supporting surface 6
Cutting wheel 3 Too much pressure applied when scoring the
snags/judders during tile
scoring
1 609 92A 1LT | (15.1.16)
1 Scoring and breaking lever
2 Breaking stamp
3 Cutting wheel
4 Guide rail
5 Rulers/Fence
6 Supporting surface
7 Carrying handle
8 Base plate
9 Transport safety-lock
10 Locking lever
11 Support extension (PTC 640)
12 Stop for serial cut (PTC 640)
Accessories shown or described are not part of the standard deliv-
ery scope of the product. A complete overview of accessories can
be found in our accessories program.

Technical Data

Tile cutter
Article number
3 603 M04 ...
Max. cutting height mm
Max. cutting length of rip
cuts mm
Mitre/Bevel Angle
Horizontal
Weight according to EPTA-
Procedure 01:2014
Corrective Measure
Apply less pressure to the scoring and
breaking lever 1 when scoring
Remove tile debris
Apply less pressure to the scoring and
breaking lever 1 when scoring
Apply more pressure to the scoring and
breaking lever 1 when scoring
Press down the locking lever 10 to lock it
Replace cutting wheel 3
Apply breaking stamps 2 right at the end
of the tile
the rulers/fence 5
PTC 640:
Fold out the support extensions 11
Apply less pressure to the scoring and
breaking lever 1 when scoring
PTC 470 PTC 640
... 3.. ... 4..
12 12
470 640
° 0–45 0–45
kg 7,4 9,1
See
graphic
8
E
11a
11b
C
Bosch Power Tools