moeve franklin Handbuch Seite 24

Mounting the pedals
1. When mounting the pedals, please note the direction of the threads [left-hand
thread/right-hand thread] [Illustration 7].
2. Combine the left cyfly® pedal spindle [label is located on the back of the
spindle] with the left pedal and the right cyfly® pedal spindle [label is loca-
ted on the back of the spindle] with the right pedal. As a rule, the pedals can
be distinguished by their labels or markings, similar to what is depicted in
[Illustration 7].
3. When screwing in the pedals, ensure that no jamming occurs.
4. The pedal threads have been pre-lubricated and do not require further
lubrication.
5. Tighten the pedals using the corresponding Allen key [6mm] with a torque of 35
Nm. Check the pedals again after the first 100 km to ensure that they are firmly
in place. Loose pedals can damage the threads and cause the bike to stall.
L R
Illustration 7
Please note: Tyre
N.B.: Check the tyre pressure on the front and rear wheels. The recom-
mended tyre pressure is between 1.5 to 4 bar.
Please note: Disk brakes
The disk brakes have been optimally adjusted by our specialist
staff. To ensure maximum brake effect and prevent brake pad gla-
zing, it is recommendable to brake with both brakes approx. 10 to 20
times at a speed of between 15 to 20 km/h before going on your first
ride. In doing so, don't be overcautious when applying the brakes.
Please avoid bedding-in the brakes on public roads to prevent ac-
cidents from happening. When bedding-in the brakes, always bra-
ke with both brakes and lean backwards to prevent you from falling.
Other adjustments and setup instructions
No other adjustments or measures are necessary, as we have already made all
the fine adjustments to all of the components such as the gearshift, brakes,
wheels and electrical contacts, and have pre-lubricated the moving parts such
as the chain etc.
EN
25