moeve franklin Handbuch Seite 23

EN
24
Adjusting and fastening the handlebar
1. Remove the screw lock at the seat post clamp using the supplied Hexlox®
safety key [Illustration 4].
2. Please turn the handlebar into the correct riding position [Illustration 2].
3. Check whether your handlebar is in the correct position and tighten the two
screws of the steerer tube clamp on the stem [Illustration 3] with an Allen key
[5mm] to the specified torque of 8 Nm. Do not over-tighten the screws, as this
could damage the threads and affect the pre-tension.
4. Insert the Hexlox® screw lock into the hex socket of the seat post clamp.
[Illustration 4]
Adjusting the saddle height and fastening the seat post
1. Remove the screw lock at the seat post clamp using the supplied Hexlox®
safety key [Illustration 4].
2. Remove the screw using a corresponding Allen key [5mm].
3. Move the saddle into the desired position [for more information on this topic,
see Item 8. Bike fitting] and ensure that the seat points towards the top tube
[Illustration 5].
4. Tighten the hscrew at the seat post clamp with the corresponding Allen key
[5mm] with a torque of 8 Nm [Illustration 6].
5. Insert the Hexlox® screw lock into the hex socket of the seat post clamp.
[Illustration 4]
Illustration 2
Illustration 3 Illustration 5
Illustration 4
Illustration 6