Ferm WEM1035 Originalbetriebsanleitung Seite 9

clockwise
electrode is orange-red.
• Current intensity too high for this type of
electrode/turn button 3 anti-clockwise
electrode spatters excessively and makes a
lot of noise during welding.
• Current intensity too high/turn button 3 anti-
clockwise
The machine is too hot; indicator lamp is on.
• The ventilation slots are blocked/clean them
with a dry cloth; wait a few minutes until the
lamp goes off again.
Repairs and servicing should only be
carried out by a qualified technician or
service firm.
cleaning
• Make sure that the ventilation slots are free of
dust and dirt. Use a soft cloth moistened with
soapy water for removing stubborn dirt. Do not
use any solvents such as petrol, alcohol or
ammonia, etc.
• Make sure that the electrode holder and earth
terminal remain corrosion-free so they can
continue making good electrical contact.
• Regularly check that welding and workpiece
cables are firmly connected in their
connections
lubrication
The machine requiers no additional lubrication.
Faults
Should a fault occur, e.g. after wear of a part,
please contact the service address on the
warranty card. In the back of this manual you find
an exploded view showing the parts that can be
ordered.
environment
To prevent damage during transport, the appliance
is delivered in a solid packaging which consists
largely of reusable material. Therefore please
make use of options for recycling the packaging.
Faulty and/or discarded electrical or
electronic apparatus have to be collected
at the appropriate recycling locations.
Only for ec countries
Ferm
Do not dispose of power tools into domestic waste.
According to the European Guideline 2012/19/EU
for Waste Electrical and Electronic Equipment
and its implementation into national right, power
tools that are no longer usable must be collected
separately and disposed of in an environmentally
friendly way.
warranty
The guarantee conditions can be found on the
separately enclosed guarantee card.
EN
9