BALDER Grand GDS Bedienungsanleitung Seite 4

BH3 HELMET AND HARD HAT ASSEMBLY
/ BH3 HH - version of BH3 helmet with Safety cap concept /
If you have purchased the BH3 welding helmet in combination with hard hat, the Speedy
Loop will be replacing the standard headgear. Please note that the holes in the helmet as
well as bolts, nuts and washers are different from those of the standard headgear.
1. Insert screws (A) through the openings in the Speedy Loop (E).
2. Insert the Speedy Loop (E) into the helmet shell (F) as shown on figure 1 and push the screws (A)
through the rectangular openings in the helmet shell.
3.
Put the tilt adjustment part (B) on the right side between the Speedy loop (E) and the helmet shell
(F). Make sure that a small pin is fixed in one of the four holes in the tilt adjustment part. Choose
the right hole for your maximum comfort.
4. Tighten the nuts (D) and washers (C1, C2) on the screws (A).
5. Place the helmet with speedy loop over the hard hat as shown on figure 2. Left and right "click"
will hold the position. If necessary, adjust the extent/diameter of Speedy Loop for optimum grip
on the helmet. Adjust the distance from the face to the welding helmet by coordinated extension/
reduction of front and rear part of Speedy Loop in order to find the most comfortable position.
6.
The headgear of the hard hat (G) can be adjusted by turning the rear wheel (H) in order to fit any
head size. Press the wheel and hold it while turning, release the wheel when reaching the posi-
tion of maximum comfort, so that it will lock in the required position.
D
C2
C1
A
E
The headgear is equipped with a replaceable sweatbands. Sweatbands are available
through your local dealer.
4
C1
A
B
F
Figure 1
C2
D
G
Figure 2
H