Kärcher WD 5.2xx M Originalbetriebsanleitung Seite 15

Rotary switch (ON/OFF)
(without built-in socket)

Position I: suction or blowing
Position 0: Appliance is switched off
(see description / illustration
Rotary switch (ON/OFF)
(with built-in socket)

Position MAX: Suction or blowing.

Position MAX: Vacuuming with con-
nected electric tool

Performance regulation: Reduce the suc-
tion if necessary during vacuuming, blow-
ing or when working with an electric tool.

Position 0: The appliance is switched off.
Electric tool is supplied with voltage.
(see description / illustration
Parking position

To rest the floor nozzle during work inter-
ruptions.
(see description / illustration
Accessory storage container

This accessory compartment allows the
storage of the suction pipes or other ac-
cessories.
(see description / illustration
Steering roller

The steering rollers are located in the
compartment when the appliance is deliv-
ered. These must be attached prior to
starting up the appliance.
(see description / illustration
Drain screw

The drain screw is used to quickly and com-
fortably empty wastewater in the container.
Tilt the container forward for easier emptying.
(see description / illustration
Filter bag
Note: Do not use a filter bag for wet vacuum-
ing!

Recommendation for appliances with-
out automatic filter cleaning:
To vacuum fine dust, use the filter bag.
(see description / illustration

The cartridge filter must always be in-
stalled - with wet and dry vacuuming.
Note: Let the wet cartridge filter dry prior
)
to using it for dry vacuuming.
(see description / illustration

Slide the suction hose into the connection,
it will lock into place.
(see description / illustration
Note: In order to disconnect it, push down
with your thumb and pull the suction hose
out.
)

Connect both suction pipes and connect
them to the suction hose.
(see description / illustration
)

Use the appropriate insert for vacuuming
on hard surfaces and carpets.
Hard surfaces, wet vacuuming: Use the
insert with 2 rubber lips.
Hard surfaces, dry vacuuming: Use the
)
insert with 2 bristles.
Carpets, wet and dry vacuuming: Work
without an insert.

For vacuuming dust from hard surfaces
)
and carpets:
Lever on symbol
Lever on symbol

For edges, joints, heaters and hard to
)
reach locations.

To connect the suction hose with an elec-
tric tool.
(see description / illustration

Adapt the adapter to the connection diameter
of the electric tool using a knife if necessary.
)
- 3
EN
Cartridge filter
(already installed in the appliance)
Suction hose with hand pipe
Suction tubes 2 x 0.5 m
Floor nozzle
(with inserts)
Floor nozzle
(with switching lever)
for carpets
for hard surfaces
Crevice nozzle
Adapter
)
)
)
)
15