Connection With The Mains; Operation; Control Via Dip Switches; Rotation Speeds - EuroLite LED Policelight Installationsanleitung

Always install the device via all fixation holes.
Do only use appropriate screws and make sure that the screws are properly connected with the ground.
Before taking into operation for the first time, the installation has to be approved by an expert!
Procedure:
Step 1: On the baseplate, there are holes for the installation.
Step 2: Hold the baseplate onto the location where the device is to be installed.
Step 3: Mark the boreholes with a pen or a suitable tool.
Step 4: Drill the holes.
Step 5: Hold the baseplate in the desired position and tighten it.

Connection with the mains

Connect the device to the mains with the power-plug.
The occupation of the connection-cables is as follows:
Cable Pin
Brown Live
Blue Neutral
Yellow/Green Earth
The earth has to be connected!
If the device will be directly connected with the local power supply network, a disconnection switch with a
minimum opening of 3 mm at every pole has to be included in the permanent electrical installation.
The device must only be connected with an electric installation carried out in compliance with the IEC-
standards. The electric installation must be equipped with a Residual Current Device (RCD) with a maximum
fault current of 30 mA.

OPERATION

After you connected the effect to the mains, the EUROLITE LED Policelight starts running.
Via the DIP-Switches on the housing, you can adjust various rotation-settings as well as rotation speeds.

CONTROL VIA DIP SWITCHES

Rotation speeds

Via DIP-Switches 1 – 7, you are able to adjust the desired rotation speed.
DIP-Switches 1 – 6 OFF, DIP-Switch 7 ON = maximum speed
DANGER TO LIFE!
International
L
N
15/32 00032319.DOC, Version 1.0