Disty distybox 300 Bedienungsanleitung Seite 14

Registration / programming
Function
Manual registration
of the distybox
300
The base station PIN needs to be entered to register the
distybox
. A PIN with 0 to 8 digits will be accepted by the
300
distybox . After entering
300
nowledge tone. Leave the handset off hook and wait until you
hear again the special dial tone, which means that the registration
is completed. If the registration process has not been completed
successfully within approx. 3 minutes, crosscheck the settings of the
base station and try again. Access to programming mode can be
protected using the four-digit PIN.
Connection to
an ISDN/analogue
line
This setting has to be used if your base station is connected to an
ISDN phone line. Send Keypad Information, while connection
Keypad information will be suppressed, so it is possible to transmit
DTMF signals.
Suppress Keypad Information: This setting has to be used if your
base station is connected to an analogue phone line.
Send always Keypad Information: This setting has to be used
if your base station is a distybase Duo or other specified ISDN
system.
Factory setting: 0
26
Parameter Other input
code
1 Base PIN #
# you will hear the positive ack-
40 0 #
40 1 #
40 2 #
Operating Instructions
Registration / programming
Function
Set PARK
number
As an option, the registration process can be carried out using the
PARK number of your DECT base station (PARK = Portable Access
Rights Key). This can have up to 15 digits. The procedure is advi-
sable if the registration process cannot be completed due to other
active DECT base stations. Please refer to the user's guide for your
base station for further details about PARK numbers.
Factory setting: no PARK number set.
Activate PARK/ARI
number
The PARK/ARI number set under programming point 80/85 is not
used during the registration process.
The PARK/ARI number set under programming point 80/85 is
used during the registration process.
Factory setting: 0
Set ARI number
Instead of the PARK number (see Parameter 80) the ARI number
can be used for subsciption. For input of the ARI number use 31 as
prefix.
Factory setting: no ARI number set.
Operating Instructions
distybox
300
Parameter Other input
code
80 PARK number #
81 0 #
81 1 #
85 31 ARI #
27